Thread: Reduction Nozzle on RXP X
01-10-2009, 08:34 PM #1
Reduction Nozzle on RXP X
I was thinking of running 81 mm ring and pitching my 15/22 to run about 8550 rpms but i'm scared that it might make it buck easier at top speeds ?? I'm running with an 82 mm on the ocean an it has plenty of hole shot I trim it all the way down and lean foward an if I hit the throtle all the way from dead stop it still hops of the line. What do you guys think would be the best combo with the X considering it has the bigger tunnel and it can process more water?? maybe an 81 really won't be the fastest top speed set up or maybe it will still work ?? Thanks for the help
01-11-2009, 02:28 AM #2
01-11-2009, 05:22 AM #3
id think maybe the 81 would be a little small if your turning 8500rpm,82 or prob 83mm would be better.
what speeds gps you at just now?
01-11-2009, 07:57 AM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By pax in forum 4-Tec PerformanceReplies: 6Last Post: 05-20-2010, 05:23 AM
By bankyf in forum Sea Doo ClassifiedsReplies: 2Last Post: 07-29-2008, 11:46 AM
By tottii in forum 4-Tec PerformanceReplies: 1Last Post: 05-18-2008, 06:53 AM
By DaveC in forum 4-Tec PerformanceReplies: 2Last Post: 07-28-2007, 02:49 PM
By meirvin in forum 4-Tec PerformanceReplies: 7Last Post: 12-01-2006, 10:53 AM