04-22-2006, 01:28 AM #1
Removal Instructions for Servo Motor Braket
Can anyone tell me how the #$*% to get the servo motor braket out? That sucker is on there tight. I've been thinking about getting a small torch and heating the hell out of the studs that go through it.
04-22-2006, 01:33 AM #2
Mine is still in. I loosened the nuts on mine and it was still stiff. I shudda just used a dremel and just cut it off. It does nothing but get in the way when removing/installing the front pipe.
04-22-2006, 01:43 AM #3
04-22-2006, 01:50 AM #4
Not what I was hoping for.
I'm going to give her some serious heat and see what happens
04-22-2006, 09:05 AM #5
04-22-2006, 09:08 AM #6Originally Posted by hydrotoys
04-22-2006, 09:22 AM #7
Wood...get off you a$$ and go put that boat in the water !!!
04-22-2006, 05:02 PM #8Wood...get off you a$$ and go put that boat in the water !!!
riGHt !! heelllloooooo ???? any new numbers yet
04-22-2006, 11:31 PM #9
04-23-2006, 12:00 AM #10
- Join Date
- Dec 2005
- new jersey - bronx
Definetly very hard to get off.. When I was doin mine I felt like I was gonna crack the damn hull. I used a chissel to sneak under the edge then banged the crap outer it.. Goodluck
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Sflwaverunner in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 12-12-2010, 10:25 PM
By slydogge in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 07-20-2010, 03:06 PM
By Pistonwash in forum Yamaha ClassifiedsReplies: 8Last Post: 02-01-2009, 02:54 PM
By CustomGP800 in forum Yamaha ClassifiedsReplies: 1Last Post: 07-14-2008, 01:58 PM
By WaveDemon in forum Yamaha ClassifiedsReplies: 1Last Post: 05-13-2008, 08:20 AM