Thread: GPR NO DISPLAY, NO fire?
02-07-2009, 12:22 PM #1
GPR NO DISPLAY, NO fire?
I just went down to the shop to start my ski after the long winter. It cranks fine, but You know the display lights up after you hit the starter button. NO display, No spark. I changed back to the stock ecm and still the same. any ideas?
02-07-2009, 01:29 PM #2
02-07-2009, 02:13 PM #3
I checked it,it was good, I was messing with the wires and then tryed it and everything worked and motor started right up, So now I guess I have to figure out what circit it is?
02-07-2009, 04:30 PM #4
A little info, I work on air conditioners for a living and now adays there is a lot of electonics in them. Many times when there are poblems its a bad conection in one the the many mulex plugs. Now the plugs on jet skis are much better made but they can still fail and fail intermitently. Heck, the fuse could have caused the poblem and when you removed it and put it back in that could have soveld the poblem. Start it up and move the wires you messed with to see if it dies. Play with the plugs, you never no.
02-07-2009, 10:37 PM #5
I had this exact problem with a couple of bad Advents but never with the stock ignition.
02-07-2009, 10:58 PM #6
- Join Date
- Nov 2008
02-07-2009, 11:33 PM #7
The question is: where does the power come from?
- I see the starter relay has two small wires.
- One would be a contact power wire,
and how does it do it?
Is the voltage sent to the IGN for just as long as the relay is pulled in?
Because under normal condtions, if you just bumb the starter the LCD lights up, and you hear the beep.
So this is what I am thinking...
so if my relay has a bad contact and does not send the voltage to the IGN. then the IGN doesn't know to turn on, it is just in stand by.
If this is not what signals the IGN to turn on what does?
02-08-2009, 12:49 AM #8
02-08-2009, 12:54 AM #9
Check the wires and harness connector to the stator all the way up to the electrical box if that's bad you will have no display or spark.
02-09-2009, 11:26 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By VdeKock in forum Yamaha ClassifiedsReplies: 0Last Post: 02-13-2013, 07:52 AM
WTB Gpr 800 displayBy ctct2118 in forum Yamaha ClassifiedsReplies: 2Last Post: 06-22-2012, 05:38 AM
FS - Parts GPR EFI display gaugeBy YudLuz2 in forum Yamaha ClassifiedsReplies: 2Last Post: 06-21-2012, 10:27 PM
By yamadood in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 04-06-2011, 04:11 PM
By snoopy in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 05-21-2007, 07:37 PM