Thread: Bar clamps
02-10-2009, 07:07 PM #1
I'm thinkin of ordering the 32" Renthal bars from the online store what clamps do you guys use for these? I don't think the stock clamps would work, I see the TAG clamps on Islandracing but not sure if these would work?
02-10-2009, 07:26 PM #2
are they the fat bars? 1-1/8" in the center? or same diameter from end to end of 7/8"
Here are some clamps on Ebay. Just grind the hump off th ebottom part if you want to fit it flush on your OEM steering mount
02-10-2009, 07:28 PM #3
Here are clamp install pics on my 2KGPR. I have Azonic CR Low Bend Fat Bars [1-1/8"] with aftermarket Moose clamps. I grinded the hump off the bottom of the clamps and mounted them flat on the OEM steering mount. TAG makes clamps too
02-10-2009, 08:04 PM #4
Thanks for the info. I not sure on the diameter I don't think it's as thin as stock if this is the case would I have to modify the trim system to work? Riva throttle etc.
02-10-2009, 08:46 PM #5
The stock bars are 7/8" and you basically only have 2 sizes. 7/8 and 1 1/8.
I use the stock clamps but clean off the stock paint and paint them up purdy...
02-12-2009, 07:47 PM #6
I ordered the moose clamps from Islandracing thanks for the help guys
02-12-2009, 07:52 PM #7
02-13-2009, 09:31 AM #8
03-19-2009, 06:08 PM #9
Stock clamps and moose clamps for a little extra rise.
03-19-2009, 06:15 PM #10
I was looking at my stockers and my moose clamps and wondering if I could do the same thing! thanks for the pics Hydro
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Duke in forum Yamaha ClassifiedsReplies: 3Last Post: 02-15-2009, 08:21 PM
By Duke in forum Sea Doo ClassifiedsReplies: 0Last Post: 02-15-2009, 10:20 AM
By gzk in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 01-23-2009, 09:36 AM
By IrishGpr05 in forum Yamaha ClassifiedsReplies: 9Last Post: 09-11-2008, 08:39 PM
By whiteyz in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 03-15-2008, 06:30 PM