Thread: Maintenance Question?
02-13-2009, 01:59 PM #1
I have an 04' ultra 150. Getting ready for the summer and checking all the nuts,bolts,
hoses etc.,and was wondering if there are any places i need to be putting/pumping grease into for bearings or anything of that nature.Any recomendations would be appreciated.Thanks
02-14-2009, 11:01 AM #2
if not here is what I think. Warning I am an Engineer and tend to overkill
my Periodic Maintenance.
1) Check/Fuel idle speed.
2)Check the oil pump cable and set gap at 0.024
3) Check/lube Choke cable
4) Check/Lube throttle cable
5) Check/Replace fuel filter
6)Check/clean Flame Arrester
7)Inspect drive coupler
Lube trim and steering linkage
check the torque of the cylinder heads and exhaust
check the torque of the pump case bolts
Here's stuff to think about based on unit hours.
1) pump seals and bearings
2) oil injection lines
3)coolant and bilge system flush
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gunnerja in forum Honda Open DiscussionReplies: 3Last Post: 08-02-2009, 04:20 PM
By jeepinwi in forum Sea Doo Open DiscussionReplies: 15Last Post: 02-26-2009, 09:35 AM
By laxidiot87 in forum MSX/MatrixReplies: 16Last Post: 07-20-2008, 09:58 PM
By tckylem in forum Kawasaki PWC Performance (4-stroke)Replies: 12Last Post: 07-10-2008, 11:24 AM
By drtbk4ever in forum Kawasaki PWC Performance (4-stroke)Replies: 3Last Post: 05-21-2008, 04:42 PM