05-05-2006, 02:19 PM #1
Not Performance but a good question...
I took the front visor off to clean the under side of it. As I was putting it back on it became alot harder to screw in the bolts into those half rubber half metal threaded things. What do you guys use to hold onto the rubber things with out ripping them??
05-05-2006, 02:56 PM #2
I used a pair of needle-nosed vice grips. They are a PITA
05-05-2006, 03:46 PM #3
Sweet, that worked. I was going to use those but I was scared it might cut through the rubber but it didn't!
05-05-2006, 09:36 PM #4
Yeah, those OEM brass nuts covered in rubber are a PITA.
I installed new ones, but if I ever do it again, I will replace them with GM Fan Shroud Retainers. They hold the fan shroud on my 99 Silverado. they push in and spread out to hold and secure the item.
05-06-2006, 12:24 AM #5
Whats the heck is a PITA ?
05-06-2006, 04:06 AM #6
- Join Date
- Jan 2006
- emerald isle
pain in the a***
05-06-2006, 06:12 AM #7
Haaaaaaaaaaaaa HA LOL ... Pain in the ass, LOL....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By big john in forum Yamaha ClassifiedsReplies: 3Last Post: 03-30-2013, 06:10 PM
By upgraded in forum eBay FindsReplies: 0Last Post: 08-17-2010, 05:00 PM
By john07ex in forum Kawasaki PWC Performance (4-stroke)Replies: 22Last Post: 09-09-2007, 07:18 AM
By hydrojunkie in forum 4-Tec PerformanceReplies: 15Last Post: 07-14-2007, 10:53 PM
By absentx in forum Polaris Open DiscussionReplies: 6Last Post: 06-10-2007, 11:43 AM