02-14-2009, 06:43 PM #1
Dynotune guage how big to drill holes??
Put the round dynotune guages on my x and now gonna put one on the t in the mirror. Got the guage comin but just made the aluminum blank and want to mill the hole....
What size hole is that again????
02-14-2009, 07:06 PM #2
If it is a 2 1/16" gauge (most likely is) then the hole is 2".
02-14-2009, 07:27 PM #3
And your right!!! Thank you thread over.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 71Last Post: 08-12-2012, 07:06 PM
By bruinsrme in forum 4-Tec PerformanceReplies: 2Last Post: 05-22-2008, 01:43 PM
By Shibby1485 in forum 4-Tec PerformanceReplies: 40Last Post: 05-03-2007, 09:36 AM
By Cody Townsend in forum 4-Tec PerformanceReplies: 14Last Post: 11-01-2005, 11:31 AM
By racerrob333 in forum 4-Tec PerformanceReplies: 1Last Post: 07-19-2005, 05:17 PM