Thread: I Need Some Parts!!! ASAP!
02-21-2009, 05:03 PM #1
I Need Some Parts!!! ASAP!
I need these parts:
2 spacers(the larger ones) out of the nozzle part where it pivots. I dont know if they are all the same in each pump. I posted pics. These came out of a 98 GP1200 65U 155mm Pump.
I also need a linage shaft for an auto drop nozzle. Either the half or full shaft. it needs to be at least 3".
This would finalize my build!
02-21-2009, 05:07 PM #2
Kris if you get me the length of the Trim tab shaft and the size of the thread (I assuming 1/4-28 Right and left hand) I can make you a set of Hex SST shafts. I do have the two spacers for the trim ring. Even better send me all the stuff, I have new SST Heim joints too, much better than the ones in the picture.
02-21-2009, 05:10 PM #3
The shaft is 3" long and 1/2" diameter. No worries on the the thread I can thread it. The problem I am having is the yolk end that pivots is locked and wont back out. When I try to back it out it feels like I am going to break the bolt off in the hole. Then I am going to need a yolk end...........I have 2 thick spacers and 2 thinner spacers. The auto drop needs 4 thick spacers. So I need 2 more.
02-21-2009, 05:20 PM #4
are those spacers the same as the trim ring?
02-21-2009, 05:21 PM #5
what is a yoke something in an egg Yolk
02-21-2009, 05:41 PM #6
HAHAHA!!!! These are out of the trim ring. My lingo is not that good when it comes to that small stuff. And the yolk = the swivle thing at the end of the shaft. It screws into the shaft.
02-21-2009, 05:49 PM #7
02-21-2009, 05:56 PM #8
02-21-2009, 09:15 PM #9
bill i need a couple of those too..ill let you know more about it when i get my tabs (by the end of the week) and get some mesurments..stainless steel turnbuckles with heim joints on either ends
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By toolman11K in forum Sea Doo ClassifiedsReplies: 14Last Post: 09-27-2009, 06:40 PM
By race24x in forum 2-Stroke PerformanceReplies: 3Last Post: 07-24-2009, 09:03 AM
By kc44408 in forum Polaris ClassifiedsReplies: 2Last Post: 07-07-2009, 09:50 PM
By Coveted in forum Yamaha ClassifiedsReplies: 0Last Post: 07-05-2008, 08:48 AM
By massSL780 in forum Polaris How To & FAQsReplies: 16Last Post: 08-28-2007, 11:58 PM