Thread: 2007 250X Valve Cover Block-Offs
02-25-2009, 10:55 AM #1
- Join Date
- May 2007
2007 250X Valve Cover Block-Offs
On 2007 250X I have installed the Billet Alum Valve Cover Block-Offs...
I was looking at online Kawa 'Valve Head Cover' parts diagram - it shows both 2007 and 2008 configs -
Since I am using Block-Off plates (as used 2008 onward)...
Can I remove the 'Reed Valve Assys'???
Or should I leave them?
02-25-2009, 04:27 PM #2
02-26-2009, 07:00 AM #3
The "reed valves" have rubber around the edges that seals the block-off to the head cover. I left mine in for that reason. Alternatively you could just add a homemade gasket or some sealant. But since it's just the head cover, it's may not leak even if you don't do this.
02-26-2009, 09:18 AM #4
02-27-2009, 10:33 PM #5
Similar to KMAN, Leave in due to rubber seal or use gasket material and fab using ball peen hammer.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By larryhood in forum Kawasaki PWC Performance (4-stroke)Replies: 1Last Post: 07-17-2010, 10:53 PM
By H2OPROOF in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 03-04-2008, 08:26 PM
By Kawi15f#12 in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 10-21-2007, 07:24 PM
By Skips313 in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 07-06-2007, 04:08 PM
By earthshaker in forum Kawasaki PWC Performance (4-stroke)Replies: 0Last Post: 06-19-2007, 08:16 PM