03-02-2009, 07:44 AM #1
RIVA Ceramic Hybrid Supercharger Bearings
Who can that tell about them?! They are necessary or not?
03-02-2009, 08:44 AM #2
I would just use the metal ones. I don't trust ceramic.
03-02-2009, 08:54 AM #3
03-02-2009, 08:57 AM #4
That's what they said about the washers too.
03-02-2009, 09:52 AM #5
03-02-2009, 11:41 AM #6
From what I know I havent heard of any ceramic bearing failures from Riva.When they were first introdused from Jerry there was an issue but has since been resolved..As far as being needed??IMO No..Is there a differance??Yes..I have 2 superchargers..One with the OEM bearings and one with the ceramics...The one with the ceramic bearings has way less drag thatn the one with the OEM bearings..Everybody will have a differant opinion on the bearings..Its pretty much personal preferance...
03-02-2009, 02:03 PM #7
03-02-2009, 05:04 PM #8
03-02-2009, 07:01 PM #9
- Join Date
- Sep 2006
- winchester va
cermanic bearings sucks i had a set was told it would handle anything i could through at it and they went in 7 hts and took a new s3 s/c and rear houseing and had to take out the motor to clean out all the crap bottom line i was out a whole lot of money i'll never use cermanic bearrings again and i dont care what anybody says
03-02-2009, 07:42 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By WFO in forum Yamaha PWC Performance (2-stroke)Replies: 66Last Post: 11-01-2012, 01:22 PM
By Chris52 in forum 4-Tec PerformanceReplies: 0Last Post: 01-21-2010, 03:18 AM
By duramaxxed in forum Sea Doo ClassifiedsReplies: 5Last Post: 10-12-2009, 04:10 PM
By duramaxxed in forum Sea Doo ClassifiedsReplies: 2Last Post: 07-14-2008, 04:59 PM
By vidbuster in forum 4-Tec PerformanceReplies: 7Last Post: 01-05-2008, 08:03 PM