Results 1 to 5 of 5
  1. #1

    How do I seal the upper and lower cases?

    Quick question. Do I put sealant around just the perimeter of the upper and lower cases, or do I need to put it in the webbing on each side of the bearings? Do you seal both halves or just one? The manual doesn't state where exactly your supposed to apply sealant. I've attached a pic for clarification.

    Thanks

    Mark
    Attached Files Attached Files


  2. #2
    Moderator RX951's Avatar
    Join Date
    Apr 2005
    Location
    League City, Texas
    Posts
    16,066
    +1
    23
    I wonder would Three Bond 1211 work like us two stroke guys use


  3. #3
    beachbum0286's Avatar
    Join Date
    Sep 2007
    Location
    Brigantine NJ
    Posts
    944
    +1
    1
    Quote Originally Posted by Mark S View Post
    Quick question. Do I put sealant around just the perimeter of the upper and lower cases, or do I need to put it in the webbing on each side of the bearings? Do you seal both halves or just one? The manual doesn't state where exactly your supposed to apply sealant. I've attached a pic for clarification.

    Thanks

    Mark
    I just split a set of cases and was wondering the same thing. I started to clean the cases and I think it goes on just the perimeter. I was going to use permatex ultra black to seal it back up with the method the manuel describes to use a small paint roller and apply it to the cases.

  4. #4
    EZ Dock of Long Island Shibby1485's Avatar
    Join Date
    May 2005
    Location
    Long Island, NY
    Posts
    9,464
    +1
    4
    use ultra-black... only on the outter mating surfaces, not the inner webbings

    thin... both halves i like to do thin... run a light bead all around, finger it down smooth and flat and rub it across the surface. just a lite film on both halves is all it takes

  5. #5
    dhoad's Avatar
    Join Date
    Aug 2005
    Location
    North Aurora, Illinois, United States
    Posts
    3,182
    +1
    6
    Quote Originally Posted by RX951 View Post
    I wonder would Three Bond 1211 work like us two stroke guys use

    I have always used three bond with success on the 2 smokes, does anyone have input on its use for the 4tec?
    thanks

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How do you seal the brass nipples at the block (951)
    By retro jet in forum 2-Stroke Performance
    Replies: 8
    Last Post: 07-18-2016, 09:32 PM
  2. Upper and Lower Case
    By bowsniper in forum Polaris Open Discussion
    Replies: 1
    Last Post: 04-22-2010, 06:34 PM
  3. How do I seal intake grate and jet pump??
    By soulhunter33 in forum Kawasaki How To & FAQs
    Replies: 2
    Last Post: 10-21-2009, 12:40 AM
  4. How do i change the bendix and remove pistons
    By cretamk in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 07-14-2007, 10:10 PM
  5. Replies: 20
    Last Post: 03-19-2007, 07:45 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •