Results 1 to 2 of 2
  1. #1

    Ultra 150 Handlebar Switch removal/ Tiny tach wire routing

    Holy cow.

    I have a 1999 Ultra 150 that I am replacing the handlebar switch on.

    There is not enough clearance in the steering stem to get the big connector through with the throttle cable in place.

    Ive pulled the vent tube down.

    Do I need to remove the throttle cable and pull it down also to make room for the 6 pin connector to pass through the steering stem hole?

    Should I route my tiny tach wiring through the steering stem also while im in there?

  2. #2
    Got it. It was all in the orientation. The throttle cable had to be in the right spot in relation to the connector.

    It can be done for future viewers w/o removing the throttle cable.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Ultra 150 starter install/removal
    By twinstack1 in forum Kawasaki How To & FAQs
    Replies: 10
    Last Post: 10-09-2016, 09:52 PM
  2. How do you remove ultra 150 handlebar grips...???
    By jcc011185 in forum Kawasaki Open Discussion
    Replies: 10
    Last Post: 05-24-2013, 03:23 PM
  3. Ultra 150 Jet Pump Removal
    By EdNewman in forum Kawasaki PWC Performance (2-stroke)
    Replies: 2
    Last Post: 08-03-2009, 07:55 AM
  4. REAL QUICK help needed... ultra 150 intake grate removal?
    By jcc011185 in forum Kawasaki Open Discussion
    Replies: 32
    Last Post: 09-12-2007, 10:01 PM
  5. Ultra 150 Drive Shaft Removal
    By twinstack1 in forum Kawasaki Tech Tips and Info
    Replies: 0
    Last Post: 06-21-2007, 10:30 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts