Thread: RIVA grate
07-13-2005, 12:23 PM #1
Got my RIVA grate from Richard Monday!! Thanks Rich!! Gonna try and put her on today. Question. Do I need to use the Red lock tite on the bolts if I'm going to fill in the holes or will Blue be ok?
07-13-2005, 12:24 PM #2
I always use red. Others use blue.
07-13-2005, 12:39 PM #3
07-13-2005, 01:28 PM #4
This is one of the few times that I will say to USE THE RED! you don't wan't that bad boy coming off!
07-13-2005, 01:56 PM #5
If you are going to fill in the holes, blue is good enough...no where for the bolts to back out too !
07-18-2005, 09:01 AM #6
Ok... dumb question. Got the grate on, now I am trying to fill the holes. I'm using 3M 5200 sealant. How the hell do you spread the stuff into the holes and keep it from just falling out (gravity)?
07-18-2005, 11:31 AM #7
I'm not sure how "Liquid" the 3M stuff is, but you could take a piece of wax paper (probably find some in a kitchen drawer) and put it up against the filled hole, held in place with duct tape. Wax paper will not let the filler stick to it and peels off easily after filler hardens.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Jeff C in forum Sea Doo Open DiscussionReplies: 6Last Post: 06-14-2006, 03:41 PM
By Totallyblown in forum Sea Doo Open DiscussionReplies: 14Last Post: 05-30-2006, 11:23 AM
By chris7613 in forum 4-Tec PerformanceReplies: 15Last Post: 04-06-2006, 04:40 PM
By 01xdime in forum 4-Tec PerformanceReplies: 8Last Post: 10-07-2005, 03:44 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 55Last Post: 09-23-2005, 10:39 AM