Thread: clean up the intake gate?
03-26-2009, 06:18 PM #1
clean up the intake gate?
Hello, i just wondering about, clean up the intake gate?
Do it corrosion after doing this? or is it the same ass stock?!
have the intake gate some protection on it or is it just polish?
can you paint the intake gate or will it just be a waste of time?
or can you polish it so it donīt corrosion?!
03-26-2009, 07:50 PM #2
- Join Date
- Jul 2008
spray it with wD40
03-26-2009, 10:08 PM #3
i think i did similar or i might have used fluid film.. had a lot of salad stuck in there during my last ride..
03-26-2009, 11:27 PM #4
i've done mine i removed the centre bar and brace then sanded smooth with a sanding wheel
it wont rust as its cast/alloy.
03-27-2009, 09:59 AM #5
03-27-2009, 11:36 AM #6
03-27-2009, 03:36 PM #7
03-27-2009, 05:36 PM #8
- Join Date
- Oct 2007
You need to use spell check and to think I thought I couldnt spell.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By wetgravity in forum Polaris Open DiscussionReplies: 1Last Post: 07-14-2009, 03:34 PM
By kenshin89 in forum 4-Tec PerformanceReplies: 11Last Post: 03-17-2007, 02:09 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 33Last Post: 04-18-2006, 04:38 PM
By Matt in forum Sea Doo Open DiscussionReplies: 2Last Post: 03-22-2006, 10:29 PM
By Sirhc7897 in forum 4-Tec PerformanceReplies: 6Last Post: 02-11-2006, 10:46 AM