Thread: engine dyno
03-27-2009, 08:39 PM #1
has anyone here actually dyno'd a 250/260 motor before and after any mod's and what were the results? not referencing kawasaki's claims.
03-27-2009, 09:19 PM #2
03-27-2009, 09:26 PM #3
i realise motec are doing one as we speak but was just curious on peoples findings.
03-29-2009, 04:56 AM #4
Yes we have had a 250 on the dyno.
The HP figures were well down and we were searching for why and realised the SC belt was not tight enough.
Tweaked up the belt and midway through the first ramp run the belt tore it self apart.
the alignment on the new steel pulley wasnt quite right.
So had to remove from the dyno and take off the pulley for correction.
12 hours to get the blimin pulley off, I hate those things.
Will get it back on toward the end of next week all going well.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By petroracing.kitins in forum Yamaha ClassifiedsReplies: 4Last Post: 10-21-2013, 12:27 AM
By smokeysevin in forum TexasReplies: 5Last Post: 12-23-2009, 07:15 PM
By MoTeC Pete in forum 4-Tec PerformanceReplies: 10Last Post: 12-03-2009, 08:49 PM
By MoTeC_Master in forum Yamaha PWC Performance (4-stroke)Replies: 99Last Post: 01-14-2009, 07:55 AM
By two2curupt in forum Sea Doo Open DiscussionReplies: 3Last Post: 03-15-2006, 11:11 AM