03-28-2009, 06:38 AM #1
Installed stage 1 kit and SS wear ring. Break-in??
Hey guys over the winter i installed a Riva stage 1 kit and SS wear ring. I'm just wondering if there is any sorta break-in i need to do when i put it in the water???The ski is an '07 RXP.
03-28-2009, 09:04 AM #2
No. start it, let it warm up for a few minutes, then drop the hammer. Only break in is from new to 10hrs.
03-28-2009, 09:11 AM #3
03-28-2009, 10:26 AM #4
first get on ski then press start button then let it warm up for a minute or two then pull right lever on the handlebar so hard that its going in the grip and then go on 4tec performance and spend more money to get to 80+++ good luck and have fun
03-28-2009, 08:21 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By linuxglobal in forum Sea Doo ClassifiedsReplies: 10Last Post: 03-12-2012, 07:57 PM
By gbest in forum Sea Doo ClassifiedsReplies: 0Last Post: 03-10-2009, 07:19 AM
By 05Limited in forum Sea Doo ClassifiedsReplies: 6Last Post: 08-29-2008, 12:46 AM
By mystahagy in forum Polaris Open DiscussionReplies: 5Last Post: 06-17-2007, 11:05 PM
By blkturbo! in forum 4-Tec PerformanceReplies: 2Last Post: 05-11-2007, 09:50 PM