04-03-2009, 10:04 AM #1
Finished piecing together my RRFPR (pics)
It took me a little while to get everything together and mounted.
Here is the parts i used,
tank fitting from turbo-tech
Here are some pics
04-03-2009, 10:08 AM #2
I used marine fuel line and brass fittings.
i had a little issue getting the fuel lines clamped on the tank fittings. 3/8 marine fuel line is a lot thicker than standard fuel injection hose.
all in all it turned out good the only thing i have left to do is mount the fuel pressure gauge. im going to remote mount it in the glove box lid with the boost gauge. I will post pic of that once its mounted
04-03-2009, 12:01 PM #3
Looks good. Do you have a link for the TT tank fitting? I was going to piece one of these together myself as well.
Also where in NJ are you located?
04-03-2009, 12:53 PM #4
04-03-2009, 01:50 PM #5
Marine hose is actually thicker so it will pass regulatory "burn through times" if it were subjected to flames. I suppose this would allow the hose to handle more pressure... but I'm not sure how much more.
04-03-2009, 02:28 PM #6
04-03-2009, 02:43 PM #7
I live in north jersey but i ride in Brick
04-03-2009, 02:56 PM #8
- Join Date
- May 2008
Looks good I was going to use an extra XS regulator I had laying around with the Turbo Tech mount. Just got to lazy and bought RUDE. Good job
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Water4fire in forum 4-Tec PerformanceReplies: 44Last Post: 10-06-2008, 07:42 AM
By jtskier11 in forum 4-Tec PerformanceReplies: 5Last Post: 04-05-2008, 10:30 PM
By WATER WOODY in forum Yamaha Open DiscussionReplies: 67Last Post: 03-05-2008, 06:35 AM
By KeithKman in forum Sea Doo Open DiscussionReplies: 18Last Post: 05-14-2007, 10:00 PM
By two2curupt in forum 4-Tec PerformanceReplies: 5Last Post: 05-20-2005, 09:54 AM