04-06-2009, 11:48 PM #1
Filling/sealing ride plate Holes??
When people fill the rideplate holes do they also use jb weld around the outside of the plate instead of the shitty factory sikaflex?
Also on a RXPX either side of the plate towards the rear the last 8-10inches there is a gap between the hull and the plate do people putty up this gap also to seal the whole plate to the hull??
04-07-2009, 03:08 PM #2
no around the outside of the plate i like many use permatex ultra black...need something to flex a little plus if you use the weld around the outside...that plate will never come off without damaging sumthing...Permatex ultrablack is the way to replace that 3m stuff that comes OEM i left that 8inch empty
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By sbaird4000 in forum Yamaha PWC Performance (4-stroke)Replies: 15Last Post: 08-24-2012, 02:59 PM
By 206 in forum 4-Tec PerformanceReplies: 1Last Post: 06-24-2008, 04:48 AM
By EAG8999 in forum 4-Tec PerformanceReplies: 1Last Post: 05-21-2008, 01:59 PM
By Rodneyae in forum Honda Open DiscussionReplies: 12Last Post: 01-02-2008, 07:47 AM
By somefun in forum 4-Tec PerformanceReplies: 5Last Post: 05-07-2006, 11:24 PM