Thread: FS: Thru Hull Exhaust Hole Saw
04-09-2009, 08:15 AM #1
FS: Thru Hull Exhaust Hole Saw
If you are planning on doing a thru hull then you need a 2 3/4 hole saw Bit. I bought one yesterday used it last night and now I will never need it again. I will save you a few bucks from buying it new and ask for $20 shipped. Let me know if you could use it!!
04-09-2009, 09:59 AM #2
04-09-2009, 12:43 PM #3
Did you have a bad experience with 2 3/4? Because it seems to me it would have to work if 5/8 is too small and i haven't seen hole saws in any increments between 5/8 and 3/4... it should work
04-09-2009, 01:12 PM #4
Ya it worked great actually, Pretty tight I was impressed.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Stockrxp in forum Sea Doo Open DiscussionReplies: 2Last Post: 12-11-2011, 09:25 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 21Last Post: 02-14-2008, 03:42 PM
By RXPDAVID in forum 4-Tec PerformanceReplies: 4Last Post: 08-03-2005, 05:05 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 46Last Post: 06-30-2005, 10:03 PM
By Compwhiz82 in forum 4-Tec PerformanceReplies: 21Last Post: 06-25-2005, 11:08 AM