Results 1 to 2 of 2
  1. #1
    The other Alex's Avatar
    Join Date
    Mar 2009
    Location
    Lake St. Clair, Michigan
    Posts
    27

    Installation of Powervalves..

    I'm having an oh-shit moment...I have two new SBT powervalves to put in my 800 motor that I am rebuilding, I went to install it and can't remember if the tapered side faces down or faces up? The stock powervalves are tapered on both the top and the bottom...I had it in facing down but it almost looked like the piston might not clear but it could have been the angle I was looking at, so I tried it facing up and it just didn't compliment the shape of the exhaust port...
    So, which way is it? Thanks.


  2. #2
    WATER WOODY's Avatar
    Join Date
    Aug 2005
    Location
    Minden, Nevada, United States
    Posts
    10,664
    +1
    11
    Welcome to the forum.Check your pm

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. How To: Installation of Rotax Racing lightweight retainers and shims
    By Green Hulk in forum Sea Doo How To & FAQs
    Replies: 2
    Last Post: 12-18-2006, 07:09 PM
  2. How To: Installation of Rotax Racing oil pressure jet
    By Green Hulk in forum Sea Doo How To & FAQs
    Replies: 1
    Last Post: 11-29-2006, 10:12 PM
  3. installation of Riva vortec?
    By Cody Townsend in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 07-20-2006, 02:47 PM
  4. Install of new propeller?
    By Totallyblown in forum 4-Tec Performance
    Replies: 8
    Last Post: 12-04-2005, 08:56 PM
  5. Pics of Installation of Bilge Pump
    By Red Devil in forum 4-Tec Performance
    Replies: 2
    Last Post: 08-14-2005, 01:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •