Thread: Bilge pump for RXPX
04-16-2009, 02:40 PM #1
Bilge pump for RXPX
I was wondering if you guys have any ideas for installing a bilge pump in rxp. I have the pump but I'm not sure where to make the water come out. Also where to buy a a finishing billet peice for the pumps hose coming out of the hull.
04-16-2009, 05:49 PM #2
I installed these items on a T-X and a GTX-SC. The RXP locations are the same, just not as much room as the "couch"!
You can get chrome/alluminum bilge pump exhaust at the online Hulk store, Overtons, Barts, West Marine.
04-16-2009, 08:27 PM #3
If you are looking at the pump from the outside, there is a spot on the left that you can hook the hose too. It is a fitting made perfect for a 3/8" hose. You just drill it out and clamp the hose to it. Make sure you loop the hose high in the hull so you don't reverse siphon water in. That is where I have hooked both of mine up since I was not a big fan of drilling into the hull. Here is a pic of where where it is located on a GTI. It looks the same on an RXP, it is just on the opposite side.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dalepatter in forum Polaris ClassifiedsReplies: 1Last Post: 09-05-2011, 10:12 PM
By abseakayak in forum Sea Doo Open DiscussionReplies: 0Last Post: 05-26-2010, 08:01 PM
By pastordug in forum Polaris ClassifiedsReplies: 3Last Post: 09-08-2009, 10:38 PM
By danieletrono in forum Sea Doo ClassifiedsReplies: 1Last Post: 02-18-2009, 02:34 PM
By mrbtd in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 02-21-2007, 06:02 AM