Thread: Cam Gear ???
04-17-2009, 06:33 AM #1
Cam Gear ???
Why does the manual show the gear with the key hole opposite the 1503 marks and the actual gear has the key hole on the same side as the 1503?
04-17-2009, 11:20 AM #2
Steve... I was perplexed by this also, and discovered that the '03-'04 engines have a gear with one timing pin hole for the timing pin, while '04+ engines have two holes located across from each other (I have no idea why unless BRP was striving for symmetry ). They probably didn't feel the need to update the picture.
04-18-2009, 03:18 PM #3
Steve... I now see that you are referring to the keyhole in the center of the sprocket. Hmmm... some graphic artist at BRP must have had a hang-over that day.
04-18-2009, 03:27 PM #4
To say the least I was worried about hitting the start button for the first time.. All is good the manual pic is wrong..
04-18-2009, 07:17 PM #5
Sea Doo had a bad manual in 2004, just check what the manual tells you to tighten the heads bolts down too!! Dont use that year manual!!
04-18-2009, 07:21 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Yamaha PWC Performance (4-stroke)Replies: 5Last Post: 08-10-2010, 06:35 AM
By yami_rida#26 in forum Yamaha PWC Performance (4-stroke)Replies: 72Last Post: 07-23-2010, 10:18 PM
By BoostedH23a1 in forum 4-Tec PerformanceReplies: 4Last Post: 07-22-2010, 08:42 PM
By BoostedH23a1 in forum 4-Tec PerformanceReplies: 0Last Post: 07-15-2010, 06:42 PM
By psycho rxp in forum 4-Tec PerformanceReplies: 37Last Post: 03-26-2006, 03:30 PM