04-19-2009, 02:20 PM #1
97 GTX faster way to clear plugged water line?
does anyone know a faster way to clear out the water line coming out from the underside of the motor going to the exhaust in the rear, the only I see is to pull the motor and remove the stinger chamber. I cut the line in the middle and was trying to loosen it with a piece of wire, but its jammed with sand and shells all the way both ends and not getting farther than a few inches either end ??
04-19-2009, 03:15 PM #2
try a blast of compressed air. Then run it on the hose to wash it all out. Worked for me.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cbrich in forum Sea Doo Open DiscussionReplies: 4Last Post: 04-22-2007, 10:02 AM
By Kinchyle in forum 4-Tec PerformanceReplies: 10Last Post: 07-08-2006, 07:28 PM
By johnD in forum 4-Tec PerformanceReplies: 25Last Post: 06-18-2006, 11:56 AM
By excess in forum 4-Tec PerformanceReplies: 8Last Post: 06-17-2006, 12:17 PM
By shooter98xpl in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 03-05-2006, 08:50 PM