04-22-2009, 11:18 AM #1
Found some good ignition wires for us
I checked the resistance on my OEM plug wires, and it's off the chart. After looking around a bit on Summit and Jegs, I found this 8mm Mallory universal wire set for $36. Only 270 ohms/foot and they look cool. Part number is MAA-775. There's 8 wires by the way, not just 4 as shown in the pic.
I also bought these wire separators for $16. Screws are SS and you'll have a few extra. Part number is MFY-5015613.
All in all, not bad for $50. Plus, I'll have some extra wires for future use or to share with a buddy. If you go in with someone, you can get a set of wires and separators for $25 total - not a bad deal.
04-22-2009, 01:34 PM #2
I'm in for a set Bruh!
04-22-2009, 03:24 PM #3
just checked my msd box and it says msd 8.5s are less than 50 ohms/foot
04-22-2009, 03:27 PM #4
Considering the factory wires are 5000+ ohms per foot, and you paid over double for your wires, I think the ones above are a good alternative.
04-22-2009, 03:32 PM #5
i think you can get 3 from riva for 40.00
you can get 8 for a SB chevy for 70.00
i got 8 on craigslist new for 35.00
but i guess if you need them right now and dont wana spend money yours are good
04-22-2009, 03:56 PM #6
I run the 8.5 msd wires if two buy in it is only $40.00 a piece, and the ski ran alot better. plus there is a ton of terminals and extra boots and wires.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By caliburst in forum Open DiscussionReplies: 41Last Post: 03-19-2009, 08:47 PM
By projektrage in forum 4-Tec PerformanceReplies: 1Last Post: 05-26-2008, 04:45 PM
By jcohen17 in forum Sea Doo Open DiscussionReplies: 1Last Post: 04-14-2008, 12:10 PM
By Darthraider in forum Yamaha Old School SkisReplies: 6Last Post: 06-20-2007, 06:11 AM
By LiquidDI in forum Sea Doo Open DiscussionReplies: 7Last Post: 03-10-2006, 01:17 AM