Thread: High temp gasket paper ..fyi
04-24-2009, 08:29 AM #1
High temp gasket paper ..fyi
been looking for hight temp gasket material to make a exhaust flange gasket for the 500's protec pipe, which is flat surface with 4 mounting holes.. as asbestos in not sellable here in the states . I needed an alternative..
Felpro PRORAMIC #2499 ,12x20x3/32 flat sheet, steel reinforced, 2 sided ceramic/paper fiber, 1200 f degrees, cuts with a med sizzors and hole punches with a gasket punch on a metal plate.. its strong enough to take a rat tail file to and clean the holes up to perfect circles.
NICE STUFF.. NAPA HAD IT!
04-24-2009, 09:01 AM #2
04-24-2009, 09:44 AM #3
was thinking of that too with red rvt for imperfections ..
but didnt like the metals mix..
stainless ,aluminum ,copper,and burnt fuel acids..hmmm
a nice little battery ..
trying to stay away from a galvanic nightmare!!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Gforce in forum 4-Tec PerformanceReplies: 14Last Post: 06-23-2008, 05:41 PM
By BDNJ in forum 4-Tec PerformanceReplies: 6Last Post: 07-06-2006, 09:32 AM
By Hecyan in forum 4-Tec PerformanceReplies: 2Last Post: 07-02-2006, 07:03 PM
By outboard john in forum 4-Tec PerformanceReplies: 4Last Post: 06-23-2006, 01:55 AM
By GILRXP in forum 4-Tec PerformanceReplies: 5Last Post: 06-01-2006, 09:59 PM