Results 1 to 6 of 6
  1. #1

    Join Date
    Jun 2007
    Location
    Little Elm, TX
    Posts
    91

    removing 760 manifold....

    I can't break it loose... Four bolts per cylinder, right? that's what the service manual shows. The reason I ask is that the engine is still in the boat and I can't see under the manifold.. Is there a bracket or something I'm missing? How much force should it take, if any, to break the seal?

    What am I missing?


  2. #2
    pilo704's Avatar
    Join Date
    Jul 2008
    Location
    dirty jerzz
    Posts
    830
    there is three bolts that you might have missed one on each end and one right in the middle..i remeber i had to make my own wrench with a mapp gas torch to get at that middle one

  3. #3

    Join Date
    Jun 2007
    Location
    Little Elm, TX
    Posts
    91
    Duh, I neglected to mention it's the exhaust manifold!

  4. #4
    pilo704's Avatar
    Join Date
    Jul 2008
    Location
    dirty jerzz
    Posts
    830
    oh haha well in that case yes 4 bolts each cyl., try prying with leverage and direct the force on the upper left side of the exh. mani that is where one of the assemble dowls are

  5. #5
    Old Ski Insanity w/rpm500's Avatar
    Join Date
    Aug 2005
    Location
    Crystal River Fl
    Posts
    2,208
    4 per port.. 6 short at perimiter, 2 long, down low inner.. one bracket in back may tie in .. check out the o/e/m parts look up for your year, to see this in exploded view..

  6. #6
    Here come the smokers! OBXJeepGuy's Avatar
    Join Date
    Aug 2008
    Location
    Outer Banks, NC
    Posts
    1,393
    It shouldn't be too terribly hard to do... I am getting great practice on mine... I can remove the entire exhaust system with my eyes closed now!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Can #2 cylinder be removed with manifold in place?
    By steach in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 02-11-2012, 08:42 PM
  2. drill and tapped intake manifold for BOV without removing the manifold
    By peterj59 in forum Yamaha PWC Performance (4-stroke)
    Replies: 16
    Last Post: 09-14-2011, 05:04 PM
  3. Need help removing exhaust manifold on MSX110 2004
    By MarkMikenis in forum Polaris Open Discussion
    Replies: 1
    Last Post: 10-17-2010, 07:09 AM
  4. Help... Removing Intake Manifold...
    By t_hoang02 in forum 4-Tec Performance
    Replies: 30
    Last Post: 06-29-2008, 08:37 AM
  5. removing intake manifold??
    By bluedlude in forum 4-Tec Performance
    Replies: 6
    Last Post: 04-02-2007, 06:09 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •