Thread: rxp-x exhaust manfiold bolts
04-30-2009, 08:15 PM #1
rxp-x exhaust manfiold bolts
So, Im about to put on my catch can and wonder what in the hell to use to get these weird looking bolts off??
Thanks in advance.
04-30-2009, 08:20 PM #2
check the link or you could use a small 12 point box in wrench like i did not sure of the size i used but make sure it goes all the way on to the head of the bolt they strip pretty easy if your not careful
04-30-2009, 08:35 PM #3
12 or 6 point 1/4 inch drive socket will do the trick.
04-30-2009, 09:53 PM #4
Ideally, you should use an E6 inverted torx socket. A six point 1/4" socket will do fine... but if you opt for a 12 point 1/4" socket make sure you have it seated squarely or you risk it slipping and rounding the head.
04-30-2009, 10:00 PM #5
yea same concern... i temp zip tied it...but y buy the torx to only do that once...i dont plan on taking the entire engine apart
04-30-2009, 10:05 PM #6
That E6 is used EVERYWHERE on the 4-tec... SC, intake, exhaust, PTO... EVERYWHERE! It is a cheap, sound investment for people who plan on the slightest wrenching of their skis.
However... a quality 6 point, 1/4", box end wrench is still needed to get some of the jobs done!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rotax racing in forum 4-Tec PerformanceReplies: 97Last Post: 04-04-2008, 01:23 PM
By Pale Rider in forum 4-Tec PerformanceReplies: 5Last Post: 08-23-2007, 07:36 PM
By JFizzleJR in forum 4-Tec PerformanceReplies: 2Last Post: 08-16-2007, 11:41 AM
By mboley in forum Polaris Open DiscussionReplies: 6Last Post: 03-13-2007, 11:10 PM
By sgaaap in forum 4-Tec PerformanceReplies: 5Last Post: 01-26-2006, 07:40 AM