06-16-2006, 07:34 PM #1
After i find my missing rpms im going to buy heads. i have a few questions..who makes the best that you all recommend? Could i do it?,i believe i can wrench pretty good. and any special styuff i should know? thanks
06-16-2006, 08:43 PM #2
The stock head. You can bet its the strongest out there and you can get just as much speed and power with a milled stock head as you can with any aftermarket head.
Just my 2 cents.
06-16-2006, 08:59 PM #3
06-16-2006, 09:12 PM #4
06-16-2006, 09:27 PM #5
so i can get my stock heads milled at half the cost and have the same performance gains and a stronger head?
06-16-2006, 09:57 PM #6
06-16-2006, 10:14 PM #7Originally Posted by MDGPR
06-17-2006, 01:13 AM #8
So who is the best??
06-17-2006, 02:48 AM #9
Originally Posted by canadaxp
- Join Date
- Nov 2005
- All over
06-17-2006, 03:06 AM #10
Stock heads appear to have better cooling too.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 05Limited in forum 4-Tec PerformanceReplies: 8Last Post: 03-14-2006, 02:12 PM
By Tube Master in forum 4-Tec PerformanceReplies: 10Last Post: 07-08-2005, 11:22 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 22Last Post: 05-22-2005, 09:18 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 18Last Post: 05-21-2005, 07:41 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 17Last Post: 05-13-2005, 08:00 AM