Results 1 to 3 of 3
  1. #1
    philip_gpr's Avatar
    Join Date
    Dec 2005
    Location
    Canada
    Posts
    2,724
    +1
    3

    Air separator - Where to install?

    Air separator - Where to install?

    I am doing 2 skis, a triple and a single piper. Any sugestions on where to install the cylinder and Fuel pump?

    If anyone has any pictures can you please post them or send them to me.

    thanks, Philip

    [email protected]


  2. #2
    Like a chimp with a ball-peen hammer smackwave's Avatar
    Join Date
    Dec 2005
    Location
    Annapolis, MD
    Posts
    621
    +1
    22
    Hey philip,

    I installed the fuel pump just behind the bracket that holds the cowling on and as high as possible, then snake the lines in an S-bend to the canister which is mounted in the hollow where the footwell meets the hood. Instead of bolts through the hull I siliconed zip-tie mounts to the hull, much like the stock zip-tie mounts for routing wiring and hoses. The canister is mounted with two zip ties above the bond line, with about a third of it hanging below the bond line. This was the best way I found for keeping the fuel pump out of the stock pipe's way, and keeping the pulse line a foot long and an uphill path from the case.

    This also made running the fuel and return lines pretty simple. I ran the "on" line to the primer and the "reserve" line to the fuel pump using the same path high on the right side of the hull. The primer lines from the primer pump then run down the canister along with the "air" line from the canister, and join the output fuel line from the canister. The "air" line T's into the return line there, and the primer and fuel lines run to the carbs with the return line.

  3. #3
    philip_gpr's Avatar
    Join Date
    Dec 2005
    Location
    Canada
    Posts
    2,724
    +1
    3
    Thanks to Mike and smackwave for their help

    I have posted some pics of Mike's install

    http://www.greenhulk.net/yamaha/viewtopic.php?t=3303

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Replies: 1
    Last Post: 07-28-2016, 07:55 PM
  2. Help, where to install depth finder?
    By HSC Limited in forum 4-Tec Performance
    Replies: 7
    Last Post: 03-28-2014, 08:24 AM
  3. Where to install a bilge pump on an ultra 150
    By JDB636 in forum Kawasaki Open Discussion
    Replies: 2
    Last Post: 05-11-2013, 09:28 AM
  4. Where to install steering extension with wedge?
    By doc212121 in forum 4-Tec Performance
    Replies: 12
    Last Post: 10-01-2007, 11:12 PM
  5. Where To Install Boost Gauge????
    By green05rxt in forum 4-Tec Performance
    Replies: 6
    Last Post: 06-05-2007, 12:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •