Thread: Grab handle repair advice
05-06-2009, 11:26 PM #1
Grab handle repair advice
Can i please have some opinions on the best way to repair the grab handle on my MSX150?
Initial thought was some sort of epoxy combined with fibaglass matt. My concern is the adheasion to the plastic. Or can i just glass this together?
Looking at the amount of damage it would need to some reinforcment.
And yes the job does look like i attempted to melt it back to gether with the soldering iron. The only positive addition was the holes I drilled to stop the cracks going further.
This was like it when i purchased it, i guess it was due to abuse.
05-06-2009, 11:45 PM #2
- Join Date
- Jul 2007
- near Toronto, Canada
How about getting a replacement from a parted out MSX?
05-07-2009, 12:41 AM #3
I must admit i have not looked, in reality Ii would need two as my other is is the same condition. I had left well enough alone until I tracked down wherel the salt on my start solenoid and ECU was comming from, there was a sizable leak through the bolt hole. I will do a search over here and see what I can come up with.
Still open for advice though
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MartyRXP in forum 4-Tec PerformanceReplies: 9Last Post: 11-21-2008, 10:21 AM
By excess in forum 4-Tec PerformanceReplies: 4Last Post: 07-28-2006, 11:51 PM
By rxpblast in forum Sea Doo Open DiscussionReplies: 0Last Post: 07-10-2006, 11:06 PM
By rxpblast in forum Sea Doo Open DiscussionReplies: 10Last Post: 04-05-2006, 06:05 PM
By ranger13 in forum 4-Tec PerformanceReplies: 23Last Post: 12-28-2005, 07:22 PM