Thread: check out my TB guard!
05-08-2009, 06:00 PM #1
check out my TB guard!
i started this project out thinking i kept gettting water in my engine but it turned out to be a bad spark plug cable... But im keeping it anyways for insurance!
05-08-2009, 06:19 PM #2
05-09-2009, 12:24 AM #3
05-13-2009, 07:51 AM #4
- Join Date
- Feb 2007
- Cape Town, South Africa
superb idea.. i think im gonna make one.
05-13-2009, 08:08 AM #5
the first 3 pics arent finished. the small last ones are finished ( i had to cut about 2 inches off the sides because the rear of the hull has a curve there)
05-13-2009, 09:07 AM #6
05-13-2009, 12:57 PM #7
you need to put some vents in it. If water gets on top of that the vibration of the engine will bounce the water right into those TB's. put some vents in like a Loover and water will drain off but not be able to splash up.
I have thought about putting a plate like that on the back right runner to keep water in the middle of the ski and not even get over that far.
05-13-2009, 07:24 PM #8
its angled in two ways
higher in the front than back and also angled so that water drains toward the motor
05-13-2009, 09:12 PM #9
Looks good Alex looks like you did your homework
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Pale Rider in forum Sea Doo Open DiscussionReplies: 6Last Post: 11-28-2005, 09:58 PM
By Water4fire in forum Other ToysReplies: 8Last Post: 11-15-2005, 08:37 PM
By NottaPhireMan in forum Sea Doo Open DiscussionReplies: 4Last Post: 09-05-2005, 11:53 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 6Last Post: 05-25-2005, 08:43 AM
By Green Hulk in forum Sea Doo Open DiscussionReplies: 14Last Post: 05-05-2005, 08:55 PM