Thread: Just installed Block off kit
05-16-2009, 06:23 PM #1
Just installed Block off kit
So I just installed my Oil block off plate, I have finally pulled the trigger and went PREMIX. Question on Premix is, Can I not just add oil to the fuel tank and then add fuel? If I know that I am going to put 10 gallons in can I not just add my ratio of oil in before or after I add the fuel?
05-16-2009, 07:05 PM #2
05-16-2009, 07:20 PM #3
If I am low on fuel, it will put 32 ounces in the take (40:1) and add 10 gallons gas. Then put five gallons in a can with 16 ounces, and use that to top off the ski. It mixed fine in the ski.
The only problem is if you put 32 ounces in but you can't add ten gallons before the ski is full, then your screwed.
or you can and 16 ounces to the tank and then 5 gallons
Just always make sure you have enough room in the tank for the gas, or you're screwed.
05-17-2009, 11:00 PM #4
I always fuel up at the pump leaving a little room for oil, then you never mix wrong and it "mixes" it up on the trailer ride to the boat ramp. Then if you want, keep 5gals in a container premixed for top offs!
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 98gsxl951 in forum 4-Tec PerformanceReplies: 4Last Post: 06-17-2011, 07:21 AM
By davidparise in forum Polaris How To & FAQsReplies: 3Last Post: 08-17-2007, 07:51 AM
By joshxp in forum Polaris Open DiscussionReplies: 4Last Post: 03-30-2007, 11:28 AM
By way2fast in forum 4-Tec PerformanceReplies: 65Last Post: 08-07-2005, 05:04 PM
By wakeborder556 in forum 4-Tec PerformanceReplies: 2Last Post: 05-09-2005, 10:29 PM