05-18-2009, 02:20 PM #1
- Join Date
- May 2009
Flipped my Ultra 250X over and got water in the engine
Has anyone dealt with this situation? I have pulled the plugs and have been trying to "pump" out the water that way. Any suggestions?
05-18-2009, 03:59 PM #2
14mm nut on end of intake manifold towards the front needs to be removed and water taken out of there. Next change oil and filter at least three times. Or until no water in oil, then check fuel if water got in there. DO THIS NOW!!!!
05-18-2009, 09:06 PM #3
05-19-2009, 12:00 AM #4
I hope that you are ok.. gotta be careful on that thing!
05-19-2009, 03:33 AM #5
crank over do again.
Remove hose on the outlet of charger and fog it now ( super charger )
as per skips site.
atleast this will stop some of the corrosion forming
get the hose of the throttle body start the ski and fog the engine
Yes you will have water in you intercooler so do as suggested
it will need to be flushed / dried out if water keep coming out of it ( remove it to be sure )
Just dont wait more than 30 seconds
06-14-2014, 11:31 AM #6
"Ditto that and look up teammotos site" can't find this do you have a link
06-15-2014, 03:46 AM #7
Wow an old thread.. team moto is gone
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Gunmetal04 in forum 2-Stroke PerformanceReplies: 15Last Post: 06-05-2013, 04:09 PM
FS - Parts 3 Ultra 250X rods and pistonsBy Marineking in forum Kawasaki ClassifiedsReplies: 13Last Post: 05-10-2013, 04:27 PM
By xjdoug in forum Kawasaki How To & FAQsReplies: 1Last Post: 07-11-2012, 10:52 AM
By Titan10s in forum Kawasaki PWC Performance (4-stroke)Replies: 37Last Post: 06-19-2009, 09:29 AM
By YoYamma in forum Sea Doo Open DiscussionReplies: 26Last Post: 07-03-2007, 10:02 PM