05-26-2009, 10:53 AM #1
Need help replacing starter for 96 Daytona 770
Have a bad starter. Heard these were hard to get to on the little shark.
I bought a heavy duty high torque starter to hopefully not have to deal with this again.
Anyone know where I can get the manual for this baby or any tips/tricks to replace the starter?
05-28-2009, 09:24 AM #2
- Join Date
- Jun 2007
- Harrisburg PA
I just pulled the stater on my 97 ts 1000 daytona last night. It's tight, but basically pull the carb rail off, take the intake/reed cage off cyc 1 & 2, and there are two bolts that hold the starter in. You might need to use a prybar to get the starter out of the engine.
I'm looking for a manual for mine as well.
05-28-2009, 02:02 PM #3
I think I had seen manuals for them on ebay.
08-29-2012, 10:06 PM #4
10-23-2012, 11:25 AM #5
- Join Date
- Sep 2012
- Raleigh, NC
just two bolts holding it in.... it is sometimes hard to plug out.... but give firm tug and plug it out
i have a starter if you need one also
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By TruRider in forum Yamaha PWC Performance (4-stroke)Replies: 4Last Post: 07-14-2012, 07:51 AM
By hockeyplayapete in forum Polaris PWC PerformanceReplies: 4Last Post: 07-09-2010, 05:27 AM
By Miss Ultra in forum Sea Doo Open DiscussionReplies: 10Last Post: 06-22-2010, 05:22 PM
By MPower in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-31-2007, 09:27 PM
By Pale Rider in forum Open DiscussionReplies: 22Last Post: 02-22-2007, 01:44 PM