07-06-2006, 05:41 PM #1
- Join Date
- Apr 2006
Stepping your Sponsons, made easy!
So its easy enough to do but figured someone might be able to use this:
A Quick note, you only really need to modify the center holes, I got a bit carried away it seems!
Let me know if its incorrect and I will fix it up =)
07-06-2006, 05:44 PM #2
07-07-2006, 10:08 PM #3
07-07-2006, 10:10 PM #4
08-02-2006, 06:35 PM #5
Thanx for the tip. The turning is greatly improved and it planes quicker.
The mod cost me six drops of loc-tite and three minutes of Dremel time.
Tip: only cut the center bolt-hole. It helps w/alignment.
01-16-2008, 07:24 PM #6
how do you guys screw the bolt in the hole with out the thread or where do you get the thread(rawl plug)
01-16-2008, 07:29 PM #7
01-17-2008, 05:44 AM #8
While you have them off, be sure to fill in the voids on the back side, especially the rear one!
05-07-2008, 08:25 PM #9
05-17-2008, 07:40 AM #10
- Join Date
- Oct 2005
Why should the void be filled in? and what would you use if so? Thanks...
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mogyver69 in forum Polaris Open DiscussionReplies: 16Last Post: 05-18-2012, 03:37 PM
By dbarks in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 03-03-2012, 10:07 AM
By yacser1 in forum 4-Tec PerformanceReplies: 1Last Post: 01-18-2010, 02:36 PM
By txgp1300r in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 05-25-2006, 02:06 PM
By nitro rxp in forum 4-Tec PerformanceReplies: 6Last Post: 05-13-2005, 08:01 AM