07-07-2006, 12:31 PM #1
Driveshaft splines - where to cut them cut?
I have a driveshaft and I need to have new splines machined into the end of it. Anybody have any idea where I can get this done?
07-07-2006, 01:19 PM #2
07-07-2006, 03:47 PM #3
I wonder if one of the aftermarket car axle companies could do this? i.e. Mark Williams, Currie, etc.?
07-07-2006, 09:12 PM #4
- Join Date
- Apr 2006
- panama city beach 'fl
strange axles for my ski, sweat will never break
07-08-2006, 01:27 AM #5
you can weld another splines from other shaft these is the way is done by the factory and these is the way i do all the time wen i need to relocate the motor or move the pump i used to pay arround $ 200 never broke one very good shop dont get cheap whit these will cost you in the long run
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By grant22 in forum Kawasaki PWC Performance (4-stroke)Replies: 7Last Post: 06-29-2012, 01:48 AM
By stealth in forum Yamaha Open DiscussionReplies: 1Last Post: 08-18-2008, 08:50 PM
By S12L00X in forum Polaris PWC PerformanceReplies: 9Last Post: 07-25-2007, 05:16 PM
By Robsauto2 in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 06-09-2006, 06:49 PM
By Chezzy in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 06-07-2006, 07:00 PM