Results 1 to 9 of 9
  1. #1

    Warning light, beep and codes....wondering??

    So i was riding today, went through 2 idle zones that were short and the ski was fine, then took off and maybe rode for 20-25 mins of constant throttle (not full throttle but around 40-45 mph) and all the sudden the warning light turns on and beeps, throwing an engine light and exhaust temperature light, ...so i shut the ski off for 5 mins started it up and cruised over to the beach, about 10 min and it didnt go back on...however then after leaving the beach about 10 min later, it happened again...so i repeated the same process, and after that it never happened again...just wondering a couple things...

    1. What could of caused this
    2. Is there anything hurt
    3.Could it just be a faulty reading??

    The ski runs good after, doesnt make any sounds, still rides smooth and just as good as before...any ideas??


    Is there an online owners manual anywhere??


  2. #2
    Faster Than a Speeding Mullet
    Join Date
    May 2009
    Location
    Tarpon Springs, FL
    Posts
    18
    sounds like its time for a D plate and the chip

  3. #3
    Quote Originally Posted by sleeperGPR View Post
    sounds like its time for a D plate and the chip

    well i just ordered those 2, now im asking does this hurt anything or is this just a "bad cat"...does it happen alot??

  4. #4
    Faster Than a Speeding Mullet
    Join Date
    May 2009
    Location
    Tarpon Springs, FL
    Posts
    18
    Quote Originally Posted by GMNTMRE View Post
    well i just ordered those 2, now im asking does this hurt anything or is this just a "bad cat"...does it happen alot??
    I would take a strong swing at saying that its not hurting anything just letting you know its getting a little on the Hot side...Why Yamaha has never fixed this problem with the cats is beyond me. My 04 GPR use to do it all the time for some reason, Runs like a champ with almost 100hrs on it....

  5. #5
    All hail the Chief! fullboogie's Avatar
    Join Date
    Nov 2005
    Location
    Texas
    Posts
    3,155
    +1
    44
    It sure would help if you guys posted up the year, make, model of your ski.

  6. #6
    Quote Originally Posted by sleeperGPR View Post
    I would take a strong swing at saying that its not hurting anything just letting you know its getting a little on the Hot side...Why Yamaha has never fixed this problem with the cats is beyond me. My 04 GPR use to do it all the time for some reason, Runs like a champ with almost 100hrs on it....

    well i will have the d-plate and ship on saturday and will install it, im assuminng by looking at the part and the chip its not hard at all...do u just plug the chip in where the plug used to be??

    Do you gain anything from these??

  7. #7
    If your not doing something, its hard to screw up. stlouisramsfan's Avatar
    Join Date
    Jul 2007
    Location
    Pontoon Beach Illinois
    Posts
    1,115
    Quote Originally Posted by fullboogie View Post
    It sure would help if you guys posted up the year, make, model of your ski.
    + 1

    this will get the stinger out...
    http://www.cajundude.com/stingerremoval.htm

  8. #8
    Quote Originally Posted by fullboogie View Post
    It sure would help if you guys posted up the year, make, model of your ski.

    damn my bad...im loosing my mind..

    2007 Yamaha Gp1300r


    I just called the old owner, and asked him if it already had the D-plate, and he told me that it did, but he never put the chip...

  9. #9
    Mike xsockguyx's Avatar
    Join Date
    Sep 2007
    Location
    NJ
    Posts
    1,744
    +1
    2
    Quote Originally Posted by GMNTMRE View Post
    damn my bad...im loosing my mind..

    2007 Yamaha Gp1300r


    I just called the old owner, and asked him if it already had the D-plate, and he told me that it did, but he never put the chip...

    the chip won't work for your that year ski. You can use a 2.2k ohm resistor you can get at Radio shack. Cut the wiring and tie it all together.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. '03 GP1300R engine warning light + beeping
    By philip5660 in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 05-07-2015, 12:46 PM
  2. Warning light and beep
    By Darks8 in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 06-11-2014, 05:21 PM
  3. '03 F12X Warning Light/Beeping No Codes
    By jmcampbell in forum Honda How To & FAQs
    Replies: 3
    Last Post: 06-04-2014, 10:17 PM
  4. Warning light and no codes???? :/
    By Venomhs7 in forum Honda Open Discussion
    Replies: 6
    Last Post: 07-09-2013, 12:06 PM
  5. '03 GP1300R Questions - warning light and engine light keep beeping
    By RoJo5000 in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 09-12-2011, 07:38 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •