06-06-2009, 02:36 PM #1
Help With 4 IN Kanaflex install NEED HELP
It is 32 degrees here today (summer in Montana) I got all the parts ready for install. The R&D supercharger coupler won't fit on the end of the supercharger as there is not enough space! This is a 2008 RXT-X the silver unit the sits behind the supercharger (near the back of the ski - the one that has insullation and a black rubber coating on it) is so close I can't get the coupler over the end. Even if I could get it over I am not sure then I could get the kanaflex over it - as the space is so small.
Has anyone ever shaved the coupler down to fit? Is there a thinner way to do this with th e4 in Kanaflex?
Thanks in advance!
06-06-2009, 03:11 PM #2
06-06-2009, 04:22 PM #3
Ok - Thanks. I went to Lowes and Home Depot and they don't have the same stuff up here as most members have in there stores - I was getting FRUSTRATED!
06-06-2009, 04:31 PM #4
06-06-2009, 04:42 PM #5
It is not to late yet - just got the strap off the water bax and am trying to move it. Thanks for the heads up!
06-06-2009, 07:46 PM #6
06-07-2009, 06:31 AM #7
06-07-2009, 07:03 AM #8
- Join Date
- Aug 2007
- Sparrows Point, MD (near the Key Bridge)
06-07-2009, 10:04 AM #9
06-07-2009, 10:41 AM #10
When you install take extra care to keep the elbow away from the carbon seal bellows. Nothing can touch the bellows or the seal will be skewed and cause the ski to sink.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By rickgreg in forum 4-Tec PerformanceReplies: 4Last Post: 08-24-2012, 01:43 AM
By Onespeednz in forum Conversion FAQ and TipsReplies: 0Last Post: 01-17-2011, 12:09 AM
By vettez062002 in forum Yamaha Old School SkisReplies: 3Last Post: 08-14-2010, 11:00 PM
By skoepp in forum 4-Tec PerformanceReplies: 21Last Post: 01-24-2008, 10:43 PM
By Shibby1485 in forum 4-Tec PerformanceReplies: 104Last Post: 09-22-2007, 09:55 PM