Results 1 to 2 of 2
  1. #1

    Needed: Machinist with Rotary Table

    Need to have a skilled machinist cut a slightly deeper O-Ring Groove for OEM spec. O-ring in (2) Cylinder Sleeves while still in the Cylinder and Hone both 717 Cylinders.

    An "un-skilled" machinist decked the Cylinders and didn't compensate with machining the groove which caused the O-ring to compress too much to the point of failure ruining two well ported, port matched cylinders.

    Let me know what you would charge for this service.

    e-mail >> [email protected]

    Thank you in advance
    David


  2. #2
    ADSR's Avatar
    Join Date
    Jul 2008
    Location
    Canadian West Coast
    Posts
    669
    +1
    2
    Post that here....

    www.practicalmachinist.com

    A lot of good guys there who can help you out.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Need help with the XLL
    By Smitty in forum Yamaha PWC Performance (2-stroke)
    Replies: 17
    Last Post: 05-23-2006, 09:39 PM
  2. Need help with pump issue
    By Flyer in forum 4-Tec Performance
    Replies: 17
    Last Post: 05-23-2006, 05:40 PM
  3. OK, need help with the small stuff now
    By Smitty in forum Yamaha PWC Performance (2-stroke)
    Replies: 9
    Last Post: 05-13-2006, 01:55 PM
  4. Need help with a Sony Handycam
    By kenshin89 in forum Sea Doo Open Discussion
    Replies: 0
    Last Post: 04-27-2006, 06:42 PM
  5. Need help with 04 S.C. rebuild
    By Turbo Todd in forum Sea Doo Open Discussion
    Replies: 4
    Last Post: 04-10-2006, 08:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •