Thread: Coil Removal
06-11-2009, 08:07 AM #1
Im trying to remove the coil out of the electrical box. Removed the plastic nuts on the outside, and boots off plug wires. The rubber grommets are not sliding out at all. Do the wires slide out of the coil, they seem not to move either. I dont want to tear anything up.
06-11-2009, 09:25 AM #2
- Join Date
- Jul 2007
- Cedar Rapids,Iowa
Your refering to the coils on the MSD No Loss set-up right?
06-11-2009, 04:50 PM #3
They're very difficult to pull out. They are just pressed in there. If you pull hard enough they will go. At least mine did on my 1200.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By fritz9981 in forum 4-Tec PerformanceReplies: 2Last Post: 06-04-2013, 09:17 PM
By jcc011185 in forum Polaris PWC PerformanceReplies: 10Last Post: 12-01-2006, 04:51 PM
By MikeTrin in forum Sea Doo How To & FAQsReplies: 8Last Post: 06-23-2005, 10:28 AM
By watermedic in forum Sea Doo Open DiscussionReplies: 6Last Post: 05-18-2005, 09:12 AM
By orc in forum 4-Tec PerformanceReplies: 3Last Post: 05-13-2005, 04:08 PM