Thread: Pump shoe removal tip
06-11-2009, 08:57 AM #1
Pump shoe removal tip
Thought I woild share this tip that has worked great for me a few times now:
After you have got the shoe/pump plug ground to give you the 'nickel' clearance, and before you seal with your prefered sealant (4200 etc) spray the surfaces to be sealed with enamel paint, leave it dry for a few hours and seal as normal.
Then if you need to remove later down the line, the shoe pulls off easily, and you just need to remove sealant- still a pain I know, but at least you don't need to stress/damgae your ski or shoe to get at it!
06-11-2009, 09:24 AM #2
- Join Date
- Oct 2006
i wish i knew that a year ago.
that tip is gold, thanks for sharing.
06-11-2009, 09:39 AM #3
Another good tip with removing 5200 is to take a metal paint scraper and heat it up with a torch... It cuts through 5200 like a hot knife through butter... DONT BREATH IT IN... It hurts
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum Sea Doo How To & FAQsReplies: 75Last Post: 10-30-2015, 06:30 PM
By rxp steve in forum Sea Doo Open DiscussionReplies: 7Last Post: 11-13-2012, 01:36 PM
By xsockguyx in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 07-26-2010, 04:10 PM
By izz0 in forum Yamaha How To & FAQsReplies: 4Last Post: 08-07-2008, 01:31 PM
By Bala in forum Kawasaki How To & FAQsReplies: 1Last Post: 05-16-2008, 12:52 AM