06-13-2009, 09:43 PM #1
jetworks riva stinger adapter any gains?
any of you guys try this mod out, prevents build up of water in the waterbox i understand , get more "bottom end and midrange" whats your feedback on this?
07 1300 gpr
r&d rideplate(ir mod 1 resurfacing)
riva top load 1200 intake
riva pump seal kit
riva ff exchaust(annoy the the neighbors)
leo,s holeshot(no stern holes)
pump tunnel reinforcement(self made)
skat trak 13/19 r155 swirl
stepped up sponsons
lubri bond-a(rideplate/trim tabs)
06-13-2009, 10:47 PM #2
06-13-2009, 11:59 PM #3
06-14-2009, 09:52 AM #4
well, EXCUSE ME, i was,nt riding back then ,but does it work on an 07 gpr or just for the 1200 or is there something similiar thats around out there that clears the waterbox fast?need even more bottom end hookup!
06-14-2009, 09:59 PM #5
06-14-2009, 10:16 PM #6
Easy install. Order the kit from Island Racing and get the stealth mod and your set.
06-15-2009, 10:25 AM #7
i called carl , wait to hear back from him , riva sell it as a combo,jetworks owns the patent on it you get up own plane quick with it?
06-15-2009, 10:57 AM #8
Carl is great and a wealth of experience on how to make your GPR faster. The jetworks kit dries out your waterbox at idle and does make a good difference on the jump ... to understand the difference a bit, idle around for a few minutes (fill the waterbox up), then floor it. Next, from WOT, come barely down to idle and immediately floor it again ... you will see a bit of how the jetworks mod works.
06-15-2009, 11:13 AM #9
yes i know exactly what you mean. I LOVEEE RIPPING HOLESHOTS from an idleing position biggest complaint keeping the rideplate 'down' when i shift from handlebars to rideplate , you could FEEEEL the difference with less water restriction?
06-16-2009, 10:05 AM #10
It is a good mod, but I would reccomend buying one of the gaskets I sell http://www.greenhulk.net/forums/show...986#post981986 (or make one) because the rubber gasket that comes with the kit ends up with holes in it over time therefore it is no longer effective. The metal gasket never goes bad so your kit continues doing what it is supposed to.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Yellow93 in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 06-03-2011, 04:55 PM
By seadoo rxt in forum 4-Tec PerformanceReplies: 2Last Post: 12-01-2008, 02:09 PM
By addicted in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 01-12-2008, 09:51 PM
By MIARider in forum 4-Tec PerformanceReplies: 3Last Post: 10-25-2007, 10:15 PM
By Yellow93 in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 04-27-2006, 04:21 PM