Results 1 to 4 of 4
  1. #1
    Petron's Avatar
    Join Date
    Aug 2008
    Location
    Boston
    Posts
    923
    +1
    1

    Propulsion needle bearings

    Guys, I'm replacing my wear ring on my Sea Doo 96 GSX.

    I have everything apart & inspecting my thrust bearing, thrust washer & needle bearings.

    The needle bearings almost feel like an interference fit, should I choose to replace them how would you go about it?

    Thanks


  2. #2
    replace them or you will scratch the shaft and you will have to replace that too

  3. #3
    Petron's Avatar
    Join Date
    Aug 2008
    Location
    Boston
    Posts
    923
    +1
    1
    winterstick, what would be the best procedure to replacing them?

  4. #4
    I just punch out the old ones and press the new ones in paying attention to the original positions or you could get the specs from the manual, Seadoo also make a tool that gets the bearings an seal positioned perfectly.
    don't use a hammer on those bearings either

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. rxp supercharger needle bearings
    By rjeffery in forum 4-Tec Performance
    Replies: 3
    Last Post: 09-01-2008, 08:41 AM
  2. Supercharger needle bearings
    By seadoo951 in forum 4-Tec Performance
    Replies: 10
    Last Post: 10-29-2007, 08:38 PM
  3. Replies: 7
    Last Post: 05-15-2007, 07:14 AM
  4. SC Needle Bearing's
    By somefun in forum 4-Tec Performance
    Replies: 6
    Last Post: 11-28-2006, 08:44 AM
  5. needle bearings on rebuild kit
    By RXPNJ in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-15-2005, 08:00 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •