Thread: Rear vent
06-18-2009, 08:44 PM #1
- Join Date
- Jun 2009
- Pace Fl.
Hello, I'm new to the site and I tried the search feature before i decided to post this question, maybe I worded t incorrectly or something, anyhow ..can that rubber plug at the rear, under the seat, be removed and replaced with a flow rite vent?
Not sure if the answer depends on what my setup is or not but just in case ... I currently have all this on order:
Top Loader intake grate
Intercooler Relocation kit
OPAS block offs
no air intake yet, still trying to decided between the Fizzle intake and the Riva rear air ...
06-18-2009, 09:08 PM #2
i think ur talking about the one that u remove to take the rear bolt out for to remove the cowling. i dont think a flow right would serve much purpose there bc i believe there is not an open space to let hot air out. people usually put em up higher on the sides to relieve the hot air inside the engine compartment
06-18-2009, 10:57 PM #3
I'm in the process of doing this right now. I haven't finished opening up and venting the inside of the cowling, and I still need to fit the Flow Rite. My concern is opening the outer hole just right so the filter will "snap out" easily for access to the mounting bolt.
06-18-2009, 11:26 PM #4
06-19-2009, 02:46 AM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Water4fire in forum 4-Tec PerformanceReplies: 27Last Post: 05-07-2014, 07:05 PM
WTB RXP Rear VentBy meeper in forum Sea Doo ClassifiedsReplies: 3Last Post: 06-11-2011, 11:22 PM
By RXP'in in MI in forum 4-Tec PerformanceReplies: 31Last Post: 09-15-2006, 08:19 AM
By RXPDAVID in forum 4-Tec PerformanceReplies: 10Last Post: 12-21-2005, 02:09 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 108Last Post: 11-07-2005, 04:07 PM