Thread: 05 RXP Steering Cable...
06-24-2009, 03:26 PM #1
05 RXP Steering Cable...
Near the end of the year last year my steering started to become sticky. So I bought a new cable for this year and have just now gotten around to installing it. I have everything disconnected, but I cannot seem to get the cable thru the rear of the hull. It seems to be getting caught up on a metal fitting of some sort. It wont push or pull thru. Any input would be great.
06-24-2009, 04:36 PM #2
06-24-2009, 04:43 PM #3
you have to undo the nut in the pump well where it comes thru the hull. I found it easier to remove the pump to do this given the tight area. Then after you remove the nut there is a C-clip behind it holding it in. if you pull on the cable from the rear just a tad the C-clips will fall out. Then you can pull the cable out thru the inside.
PS: you will have to remove the connector on the end to pull it thru.
06-24-2009, 04:44 PM #4
oh, and yes...
I am currently going thru the same issue. I am trying too find a new cable right now to order.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By caliburst in forum Sea Doo ClassifiedsReplies: 10Last Post: 04-30-2010, 11:24 AM
By caliburst in forum Conversion Skis ClassifiedsReplies: 0Last Post: 04-29-2010, 09:04 PM
By Seadooracer9 in forum Sea Doo ClassifiedsReplies: 3Last Post: 08-29-2009, 10:01 PM
By NJMatt50 in forum 4-Tec PerformanceReplies: 0Last Post: 05-26-2009, 07:46 AM
By NJMatt50 in forum Sea Doo ClassifiedsReplies: 0Last Post: 05-14-2009, 09:53 PM