06-27-2009, 08:50 AM #1
reed stuffers is it all made out to be?
i read on the forums at green hulk u. that the gains are nil if any, they warp, its seems to be a good mod for me because of low end acceleration what's the deal ?
r&d rideplate(ir mod 1 resurfacing)
riva top load 1200 intake
riva pumpshoe seal
riva ff exchaust(annoy the neighbors)
leo's holeshot(no stern holes)
skat trak 13/19 r 1555 swirl
pump tunnel reinforcement(self made)
stepped up sponsons
lubri bond a
COMMING SOON I.R. JETWORKS HOLESHOT,RIVA POWER FILTER, D PLATE,SKAT TRAK 87MM DROP NOZZLE
06-27-2009, 09:12 AM #2
I removed mine and threw them in a corner of the garage......I cant tell any differance.
06-27-2009, 09:33 AM #3
yea , thats what i been reading , also i should put a efi control in, otherwise i run "lean" more$$, vf3 reed cages WHOA!$$
06-27-2009, 09:55 AM #4
- Join Date
- May 2007
- Buzzards Bay, Massachusetts
yea you should do an efi controller...those VF3s reallly wake your engine up...and it will create a lean condition.
06-27-2009, 10:06 AM #5
06-27-2009, 10:20 AM #6
06-27-2009, 10:40 AM #7
06-27-2009, 11:48 AM #8
I have not used reed stuffers but heard they are a waste of money save for the vf3 kit maybe you can find a good low hour set thats what i did.
06-27-2009, 09:12 PM #9
cost vs result
cost of vf3s and an efi controller , we're looking at close to a G, WELL, HOW MUCH HOLESHOT WE GETTING , 1 ,2 BOAT LENTHS?
06-27-2009, 09:49 PM #10
I say they are a benefit, The issue with the VF-III's can be overcome.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Cliferton in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 02-11-2012, 12:23 PM
By polaris.msx in forum Polaris PWC PerformanceReplies: 13Last Post: 05-17-2011, 05:08 PM
By Hydrotherapy in forum Yamaha Open DiscussionReplies: 0Last Post: 11-08-2006, 05:12 AM
By VegasRatt in forum Polaris PWC PerformanceReplies: 7Last Post: 10-15-2006, 02:15 PM
By bad93blaster in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 05-31-2006, 08:43 PM