07-07-2009, 01:33 PM #1
Pump rebuild question... Need help, I'm stuck!
Silly question here but I’m stuck until I can get it answered. Last night I started rebuilding my very first jet pump on a 1998 SeaDoo SPX . (The wear ring was too thin and the thrust washer was also worn.)
Anyway… I have the pump off the craft. Nose cone is pulled off, impeller is removed, wear ring is removed, and the two inner bearings and seal are removed. I bought a rebuild kit from SBT but in the package are three small O rings. (See picture) What are these for? I didn’t see them when I pulled things apart.
I’ve got the SeaDoo manual but this particular section has few pictures and is hard to follow. Anyone care to step me through the final steps? I want to make sure I put this thing back together correctly. Any watchouts as I assemble this thing back together??
07-07-2009, 02:07 PM #2
I don't see three in that pic, but I see two small, one medium and one large.
The 2 small will go to your bailer tubes where the pump mounts to the hull, the medium is for the water inlet tube and the large is for your pump cone.
07-07-2009, 02:11 PM #3
Great! That is the info I was needing.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By PEVO in forum Kawasaki PWC Performance (2-stroke)Replies: 2Last Post: 04-16-2009, 09:27 AM
By 1fastrat in forum 2-Stroke PerformanceReplies: 18Last Post: 08-25-2008, 11:07 AM
By Bigcat1 in forum 4-Tec PerformanceReplies: 3Last Post: 05-25-2008, 04:17 PM
By rob2337 in forum Polaris Open DiscussionReplies: 5Last Post: 04-02-2008, 06:17 PM
By gotpurp305 in forum 4-Tec PerformanceReplies: 3Last Post: 04-11-2006, 10:27 PM