Thread: 700 slt ignition
07-12-2009, 02:21 PM #1
- Join Date
- Jul 2009
- Lake Sinclair,
700 slt ignition
Does anyone have a step by step orcedure for testing the CDI and the coil pack, My 700 ran on Fri and get no spark to the plugs on Sat. Full charged battery
07-12-2009, 02:45 PM #2
- Join Date
- Jul 2007
- near Toronto, Canada
Click below for the service manual, and other useful links.
Check the battery voltage while the engine is cranking. Must be over 10.5 volts while cranking, or no spark.
If battery is over 10.5 cranking volts, then clean both ends of both battery cables, and all red wires on the start solenoid.
If still no spark, check voltage on Red/Purple wire that feeds into CDI ignition module, with the other meter probe on the Black wire into the CDI. Again, must be over 10.5 volts while cranking.
If you have good voltage into the CDI, then look here;
How do I test old and new domestic red engine CDI, Magneto and Ignition coils?
My ohm-meter measurements don't exactly agree with the service manual specifications. Is this OK?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By arsxlt in forum Polaris ClassifiedsReplies: 2Last Post: 05-30-2009, 08:24 AM
By 01durango in forum Polaris ClassifiedsReplies: 0Last Post: 07-17-2008, 11:34 PM
By neal233 in forum Polaris Open DiscussionReplies: 5Last Post: 06-16-2008, 04:31 PM
By samitala in forum Polaris PWC PerformanceReplies: 9Last Post: 09-18-2007, 09:59 AM
By Got Diesel in forum Polaris Open DiscussionReplies: 18Last Post: 04-10-2007, 11:02 AM