FS 01 gpr hull set up for seadoo conversion

[Dirty Sanchez]

Too much to list but I'll try.
-hull cut and modified for seadoo conversion
-2 stock rear mounts
-ft solid pirihna mount
- ft motor mount plate
- ft custom battery tray
- rear mount brackets
- rear mid wall trimmed / modified
-cut seadoo drive shaft on Yamaha mid shaft carrier
-solid intake grate block
- upgraded drive shaft hose reinforced with wire
-carbon fiber tunnel reinforced
-hole shot rear hull epoxy edge fill in
-2in pump spacer
-two pressure bleed off valves
Trim and steering cables good
Trim and steering cable extensions
- exotic signs/ riva racing graffics
- new seat cover
- cut inner hood for ventilation
4in air filter and custom bracket under steering
Dash pre cut to accept seadoo gauges
- pump shoe sealed
- stainless steel 800 grate
- pump shoe brackets
- Jim's plate
-alignment plate
Riva sponsons

[Dirty Sanchez]

I'll post hull Id and title pix when I'm back in town

[Dirty Sanchez]

Exterior pix
I also have a 2nd hull

[Dirty Sanchez]

Riva or r&d extended trip tabs
Billet thru hull fitting minus -1
Hydro turf mats

[Dirty Sanchez]

Bracket to mpem included, but not mpem. No electronics
, no exhaust , no wiring and no motor.

Just take donor seadoo and instant conversion ski

[Dirty Sanchez]

Motor mounts and brackets

[frogurt]

PM sent

[frogurt]

Is this still available?

[crackeboy]

How much

[Dirty Sanchez]

1600.00
Black handle bars
Trim and grips included
3 trim cables and real included

Riva blue free flow silicone hose included

[Dirty Sanchez]

More pix hull with all parts 1600.00

All parts and hull with title 1600.00

[Dirty Sanchez]

Pix added

[Dirty Sanchez]

1000.00 takes it all

[frogurt]

PM SENT

[Dirty Sanchez]

Replied