Heat Exchanger install on a gpr

[shooter98xpl]

Where you guys installing your heat exchangers at in the conversion skis? Got pics?
SHOOTER

[beerdart]

Above the tunnel..

[mrbtd]

Mine is tucked in back of the I/C next to the exhaust outlet. Its very tight but works.

[shooter98xpl]

BD does that not interfere with your trim cable?
are you guys laying it on anything or just strapping it straight down to the hull?

[beerdart]

You need to make a cutout in the bracket for the cable.

[shooter98xpl]

BD thanks for the 2nd pic, much better and I see how you did it. Guess I need to find some more aluminum. I am going to assume it doesn't interfere with the freeflow tube?
SHOOTER

[beerdart]

Its tight but clears.

[shooter98xpl]

cool, will take a look tomorrow on mine.
Big thanks.
SHOOTER

[Inkaddict]

Same idea as Beerdart... He just had nicer brass fittings

[shooter98xpl]

BD and Ink, what size plate you guys running?
How thick of a piece of aluminum are you using?
Thanks guys, I really appreciate it.
SHOOTER

[Inkaddict]

Mines a 16 plate and the mount is 1/4 inch aluminum... Im probably going to wind up using a 30 plate but I wanted to try the 15 first to see if it was efficient enough.

[Danny]

Your wate routing will determine what size HX you run...

[RX951]

I'm so close to ditching this ball valve.

[Inkaddict]

I'm so close to ditching this ball valve.

[shooter98xpl]

actually my HX will determine my water routing as I already bought the 30 plate, hahahaha. I have no choice now in the decision.
But, I am going to go make my bracket here in a minute.

I am going to say you guys put a rubber mat on the bracket, put the HE on that, then made a straight bar across the top and bolted it down on each side to the HE to hold it in place correct?
SHOOTER